My hobby is mainly Judo.
I also to learn Danish in my free time.
Also visit my site buôn bán thu... View More
January 18, 2026
6 views
Metro seal is used for transformer relay applications due to its superior sealing properties, which protect against contaminants like dust and moisture. This en
Read more
Electrical Engineering
How a single phase double wound transformer works to produce variable voltages?
Asked by Anonymous
A single-phase double-wound transformer, consisting of primary and secondary windings, operates on the principle of electromagnetic induction. When an alternati
Read more
Electrical Engineering
What type of phrase is Hurrying up the winding staircase?
Asked by Anonymous
"Hurrying up the winding staircase" is a gerund phrase. It begins with the gerund "hurrying," which acts as a noun, and includes the preposi
Read more
Electrical Engineering
What is One disadvantage of this type of circuit?
Asked by Anonymous
One disadvantage of a series circuit is that if one component fails or is disconnected, the entire circuit stops functioning. This can lead to an interruption i
Read more
Electrical Engineering
How the shunt reactor transfomer work in transmission line?
Asked by Anonymous
A shunt reactor transformer is used in transmission lines to manage reactive power and voltage levels. It operates by absorbing excess reactive power during low
Read more
Environmental Issues
+2
What research has been done on superconducting ceramics for use of very fast trains?
Asked by Anonymous
Research on superconducting ceramics, particularly high-temperature superconductors (HTS), has focused on their potential for magnetic levitation systems in ver
Read more
Electrical Engineering
How much current will split AC consume?
Asked by Anonymous
The current consumption of a split AC unit depends on its cooling capacity, typically measured in BTUs, and its energy efficiency ratio (EER) or seasonal energy
Read more
Electrical Engineering
Explain why d. The neutral position of the brushes is indicated by a red line marked on the motor housing.?
Asked by Anonymous
The neutral position of the brushes is indicated by a red line on the motor housing to provide a clear visual reference for proper alignment. This position is c
Read more
Electrical Engineering
WHAT SIZE WIRE FEEDS A 37 KVA LOAD?
Asked by Anonymous
To determine the appropriate wire size for a 37 kVA load, you need to consider the voltage and the length of the run. For a typical three-phase system at 480 vo
Read more
Electrical Engineering
When nonmetallic sheathed cables are bunched or bundled together for distances longer than 24in. (600mm) what happens to their current carrying ability?
Asked by Anonymous
When nonmetallic sheathed cables are bunched or bundled together for distances longer than 24 inches (600 mm), their current-carrying ability can be reduced due
Read more
Electrical Engineering
+1
What is the latest color identification of a 3 phase supply?
Asked by Anonymous
The latest standard color identification for a three-phase electrical supply, as per IEC 60446, includes brown for phase L1, black for phase L2, and gray for ph
Read more
Electrical Engineering
Why IDMT relays are widely used for over-current protection?
Asked by Anonymous
IDMT (Inverse Definite Minimum Time) relays are widely used for over-current protection due to their ability to provide flexible and adaptive response times bas
Read more
Electrical Engineering
How many current in amperes when 20C flow past a point in a wire 4s?
Asked by Anonymous
To find the current in amperes, you can use the formula ( I = \fracQt ), where ( I ) is the current, ( Q ) is the charge in coulombs, and ( t ) is the time
Read more
Electrical Engineering
What is EEFC AC?
Asked by Anonymous
EEFC AC refers to the "External Economic and Financial Cooperation Account," which is a financial instrument used by certain countries to manage forei
Read more
Electrical Engineering
What happens to the value of resistance when the ammeter value decreases?
Asked by Anonymous
When the ammeter value decreases, buôn bán thuôc nổ it indicates that the current flowing through the circuit is lower. According to Ohm's Law (V = IR), if the voltage remains co
Read more
Electrical Engineering
How much transformer oil needed to top-up?
Asked by Anonymous
The amount of transformer oil needed for a top-up depends on the specific transformer design, its capacity, and the level of oil loss due to leaks or maintenanc
Read more
Electrical Engineering
What is of over voltage fault?
Asked by Anonymous
An overvoltage fault occurs when the voltage in an electrical system exceeds its designated limits, potentially causing damage to equipment and increased risk o
Read more
Electrical Engineering
How do you restart a self winding watch that has stopped?
Asked by Anonymous
To restart a self-winding watch that has stopped, gently wind the crown clockwise about 20 to 30 times to provide initial power to the movement. After winding,
Read more
Electrical Engineering
How many transformers are used in Scott connection?
Asked by Anonymous
In a Scott connection, typically two transformers are used: a main transformer and a teaser transformer. The main transformer is connected to the primary three-
Read more
Electrical Engineering
How large is a DC-10?
Asked by Anonymous
The McDonnell Douglas DC-10 is a wide-body, three-engine jet airliner with a typical length of about 182 feet (55.4 meters) and a wingspan of approximately 165
Read more
Electrical Engineering
Does the length of a coil affect the inductance value of a coil?
Asked by Anonymous
Yes, the length of a coil affects its inductance value. Generally, as the length of the coil increases, the inductance also increases due to the greater number
Read more
Electrical Engineering
Who is the top leader of dc?
Asked by Anonymous
As of my last update in October 2023, the top leader of Washington, D.C., is the Mayor. The mayor is responsible for the city's government and administration. A
Read more
Electrical Engineering
In plate earthing the thickness of copper plate is?
Asked by Anonymous
In plate earthing, the thickness of the copper plate is typically recommended to be at least 3 mm. This thickness ensures adequate conductivity and durability w
Read more
Electronics Engineering
+2
What are the theory about Programmable Logic Controllers using PIC micro-controllers?
Asked by Yllen
Programmable Logic Controllers (PLCs) using PIC microcontrollers are designed to perform automation tasks in industrial settings. The theory behind these system
Read more
Electrical Engineering
+1
How do I calculate the current capacity of copper or alumium busbar used in a substation?
Asked by Anonymous
To calculate the current capacity of a copper or aluminum busbar in a substation, you need to consider factors such as the material's conductivity, cross-sectio
Read more
PreviousNext
Trending Questions
Why does the television need to be connected to the isolation transformer before it is connected to the power source? What is the minimum acceptable reading for magger test for 480v motor? Is an electric train faster then a steam one? How to check 220-240 volt single phase capacitor start motor if it will not start? What is meant by the phase " whitewashed" when used in terms of the media? What advantage in a parallel twin-cylinder motor does a 180 degree crank have over a 360 degree one? What does the crank do in a generator? What power is in 3 phase? If two bulbs in a series are connect to a battery and the current in the first bulb is found to be 1 ampere then what is the current through the battery? How To Sell Your Used Diesel Generator? What does the commutator in an electrical motor do? Why autotransformers are not safe for supplying low voltage from a high voltage source? What is a switchgear room? If voltage equals resistance x current then? What are the different ways of constructing a multiway if-else structure? What is the maximum load of a grade 2 ladder? What does a flux density do in a single phase tramsformer? What is the Difference between resistive and capacitive load? What is the firing angle of silicon controlled rectifier? In the potentiometer resistance increases gradually then why fan speed increases?
Resources
Leaderboard All Tags Unanswered
Top Categories
Algebra Chemistry Biology World History English Language Arts Psychology Computer Science Economics
Product
Community Guidelines Honor Code Flashcard Maker Study Guides Math Solver FAQ
Company
About Us Contact Us Terms of Service Privacy Policy Disclaimer Cookie Policy IP Issues
Copyright ©2025 Infospace Holdings LLC, A System1 Company. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Answers.
Be the first person to like this.